A comparison of mvM stress of inlays, onlays and endocrowns made from various materials and their bonding with molars in a computer simulation of mastication - FEA.

OBJECTIVES: The purpose of the study was to compare the mvM stresses occurring in inlays, onlays and endocrowns made from different materials and their bonding with molars in a computer simulation of mastication.

METHODS: The study was conducted using the finite elements method with contact elements. Sixteen 3D first molar models were created of a intact tooth - T; a tooth with a ceramic inlay - IN; a tooth with an onlay - ON; and a tooth with an endocrown - EN. The restorations were made of: Comp - resin nanoceramic; Hc - hybrid ceramic; Le - leucite ceramic; Dlit - lithium disilicate; and Zr - zirconia. Computer simulations of mastication were performed. The equivalent stresses according to the modified von Mises criterion (mvM) were calculated in model materials and contact stresses at the interface cement-dental tissue around the examined restorations.

RESULTS: The highest equivalent mvM stresses were concentrated in buccal margins of inlays. The mvM stresses recorded in onlays were 1.6-5 times lower than those found in inlays, while in endocrowns they were 2.3-6.5 times lower. Around the onlays and endocrowns, in tooth structures and luting cement, mvM stresses were significantly lower compared to teeth restored with inlays. The tensile and shear contact stresses between inlays and teeth were several times lower than under another restorations. The highest stresses (58.5MPa) occurred in the zirconia inlay. The stresses observed in the enamel of a tooth restored with an INZr inlay were half those noted in INComp, and a third of those observed in cement. Tensile contact stresses at the interface between the INZr inlay and dental tissue were 4.5 times lower than in the INComp, and the shear stresses were more than 7 times lower.

SIGNIFICANCE: The highest values and unfavorable of stress levels occurred in teeth restored with inlays. Cavities MOD in molars should be reconstructed with cusp-covering restorations. The endocrown in molars should withstand physiological loading. The higher the modulus of elasticity of the restoration material, the higher the stresses in the restorations, while the lower stresses were observed in the tooth structures, luting cement and at the interface between the restoration and the dental tissue. Ceramic restorations should provide better protection and marginal seal of the reconstructed tooth than composite ones.