Self-power

Emerging organic photoelectrochemical transistors (OPECTs) with inherent amplification capabilities, good biocompatibility and even self-powered operation have emerged as a promising detection tool, however, they are still not widely studied for pollutant detection. In this paper, a novel OPECT dual-mode aptasensor was constructed for the ultrasensitive detection of di(2-ethylhexyl) phthalate (DEHP). MXene/In2 S3 /In2 O3 Z-scheme heterojunction was used as a light fuel for ion modulation in sensitive gated OPECT biosensing...

We have developed a self-powered near-infrared photodetector (PD) with high detectivity using a tensile strained Ge layer capped with a thick Si layer. The Si layer acts as a stressor and maintains the strain of Ge with minimal dislocations by creating a rough surface. By using Raman spectroscopy, we confirmed that the Ge layer has a 1.83% in-plane tensile strain. The Ge PD exhibits a high responsivity of 0.45 A/W at -1 V bias voltage for 940 nm wavelength. The PD's dark current density is as low as ∼1...

Self-powered deep ultraviolet photodetectors (DUV PDs) are essential in environmental monitoring, flame detection, missile guidance, aerospace, and other fields. A heterojunction photodetector based on p-CuI/n-ZnGa2 O4 has been fabricated by pulsed laser deposition combined with vacuum thermal evaporation. Under 260 nm DUV light irradiation, the photodetector exhibits apparent self-powered performance with a maximum responsivity and specific detectivity of 2.75 mA/W and 1.10 × 1011 Jones at 0 V...

Ultraviolet photodetectors (UV PDs) have attracted significant attention due to their wide range of applications, such as underwater communication, biological analysis, and early fire warning systems. Indium oxide (In2 O3 ) is a candidate for developing high-performance photoelectrochemical (PEC)-type UV PDs owing to its high UV absorption and good stability. However, the self-powered photoresponse of the previously reported In2 O3 -based PEC UV PDs is unsatisfactory. In this work, high-performance self-powered PEC UV PDs were constructed by using an In2 O3 nanocube film (NCF) as a photoanode...

Recently, certain ferroelectric tunnel junctions (FTJs) exhibit non-volatile modulations on photoresponse as well as tunneling electroresistance (TER) effects related to ferroelectric polarization states. From the opposite perspective, the corresponding polarization states can be read by detecting the levels of the photocurrent. In this study, we fabricate a novel amorphous selenium (a-Se)/PbZr0.2 Ti0.8 O3 (PZT)/Nb-doped SrTiO3 (NSTO) heterojunction, which exhibits a high TER of 3 × 106 . Unlike perovskite oxide FTJs with a limited ultraviolet response, the introduction of a narrow bandgap semiconductor (a-Se) enables self-powered photoresponse within the visible light range...

Highly efficient water splitting electrocatalyst for producing hydrogen as a renewable energy source offers potential to achieve net-zero. However, it has significant challenges in using transition metal electrocatalysts as alternatives to noble metals due to their low efficiency and durability, furthermore, the reliance on electricity generation for electrocatalysts from fossil fuels leads to unavoidable carbon emissions. Here, a highly efficient self-powered water splitting system integrated is designed with triboelectric nanogenerator (TENG) and Ni3 FeN@Fe24 N10 catalyst with improved catalytic activity and durability...

Developing a robust artificial intelligence of things (AIoT) system with a self-powered triboelectric sensor for harsh environment is challenging because environmental fluctuations are reflected in triboelectric signals. This study presents an environmentally robust triboelectric tire monitoring system with deep learning to capture driving information in the triboelectric signals generated from tire-road friction. The optimization of the process and structure of a laser-induced graphene (LIG) electrode layer in the triboelectric tire is conducted, enabling the tire to detect universal driving information for vehicles/robotic mobility, including rotation speeds of 200-2000 rpm and contact fractions of line...

Precise agriculture based on intelligent agriculture plays a significant role in sustainable development. The agricultural Internet of Things (IoTs) is a crucial foundation for intelligent agriculture. However, the development of agricultural IoTs has led to exponential growth in various sensors, posing a major challenge in achieving long-term stable power supply for these distributed sensors. Introducing a self-powered active biochemical sensor can help, but current sensors have poor sensitivity and specificity making this application challenging...

Integrating flexible triboelectric nanogenerators (TENGs) into firefighting clothing offers exciting opportunities for wearable portable electronics in personal protective technology. However, it is still a grand challenge to produce eco-friendly TENGs from biodegradable and low-cost natural polymers for mechanical-energy harvesting and self-powered sensing. Herein, conductive polypyrrole (PPy) and natural chitosan (CS)/phytic acid (PA) tribonegative materials were employed onto the Lycra fabric (LC) in turn to assemble the biodegradable and flame-retardant single-electrode mode LC/PPy/CS/PA TENG (abbreviated as LPCP-TENG)...

Extreme climates have become frequent nowadays, causing increased heat stress in human daily life. Personal thermal management (PTM), a technology that controls the human body's microenvironment, has become a promising strategy to address heat stress. While effective in ordinary environments, traditional high-performance fibers, such as ultrafine, porous, highly thermally conductive, and phase change materials, fall short when dealing with harsh conditions or large temperature fluctuations. Aerogels, a third-generation superinsulation material, have garnered extensive attention among researchers for their thermal management applications in building energy conservation, transportation, and aerospace, attributed to their extremely low densities and thermal conductivity...

Water-induced electricity harvesting has gained much significance for energy sustainability. Bio-based hydrovoltaic materials increase the attractiveness of this strategy. Although promising, it faces a challenge due to its reliance on fresh water and its inherently low power output. Herein, the energy from alkalinity-gradient power generation demonstrated the feasibility of reuse of alkaline wastewater to develop an all-wood-based water-induced electric generator (WEG) based on ion concentration gradients...

Light detection and ranging (LiDAR) is indispensable in applications such as unmanned aerial vehicles, autonomous driving, and biomimetic robots. However, the precision and available distance of LiDAR are constrained by the speed and sensitivity of the photodetector, necessitating the use of expensive and energy-consuming avalanche diodes. To address these challenges, in this study, a pyroelectricity-based acceleration strategy with 2D-(graded 3D) perovskite heterojunction is proposed to achieve a record high speed (27...

Tissue engineering and electrotherapy are two promising methods to promote tissue repair. However, their integration remains an underexplored area, because their requirements on devices are usually distinct. Triboelectric nanogenerators (TENGs) have shown great potential to develop self-powered devices. However, due to their susceptibility to moisture, TENGs have to be encapsulated in vivo. Therefore, existing TENGs cannot be employed as tissue engineering scaffolds, which require direct interaction with surrounding cells...

17β-Estradiol (E2) is an important endogenous estrogen, which disturbs the endocrine system and poses a threat to human health because of its accumulation in the human body. Herein, a biofuel cell (BFC)-based self-powered electrochemical aptasensor was developed for E2 detection. Porous carbon nanocage/gold nanoparticle composite modified indium tin oxide (CNC/AuNP/ITO) and glucose oxidase modified CNC/AuNP/ITO were used as the biocathode and bioanode of BFCs, respectively. [Fe(CN)6 ]3- was selected as an electroactive probe, which was entrapped in the pores of positively charged magnetic Fe3 O4 nanoparticles (PMNPs) and then capped with a negatively charged E2 aptamer to form a DNA bioconjugate...

Real-time monitoring of rainwater is a critical issue in the development of autonomous vehicles and smart homes, while the corresponding sensors play a pivotal role in ensuring their sensitivity. Here, we study a self-powered intelligent water droplet monitoring sensor based on a solid-liquid triboelectric nanogenerator (SL-TENG). The sensor comprises a SL-TENG, a signal acquisition module, a central processing unit (CPU), and a wireless transmission module, facilitating the real-time monitoring of water droplet signals...

The increasing number of IoT devices has led to more electronic waste production, which harms the environment and human health. Self-powered sensor systems are a solution, but they often use toxic materials. We propose using biocompatible peanut skin as the active material for a self-powered humidity sensor (PSP-SPHS) through integration with a peanut-skin-based triboelectric nanogenerator (PSP-TENG). The PSP-TENG was characterized electrically and showed promising results, including an open circuit voltage (162 V), short circuit current (0...

With the vigorous development of the Internet of Things, 5G technology, and artificial intelligence, flexible wearable sensors have received great attention. As a simple and low-cost power supply in wearable sensors, the triboelectric nanogenerator (TENG) has a wide range of applications in the field of flexible electronics. However, most polymers are thermally poor conductors (less than 0.1 W/(m·K)), resulting in insufficient heat dissipation performance and limiting the development of TENG. In this study, a high-performance non-woven fabric TENG with strong thermal conductivity (0...

Flexible supercapacitors (FSCs) with high electrochemical and mechanical performance are inevitably necessary for the fabrication of integrated wearable systems. Conducting polymers with intrinsic conductivity and flexibility are ideal active materials for FSCs. However, they suffer from poor cycling stability due to huge volume variations during operation cycles. Two-dimensional (2D) materials play a critical role in FSCs, but restacking and aggregation limit their practical application. Nanocomposites of conducting polymers and 2D materials can mitigate the above-mentioned drawbacks...

With the advent of the Internet of Things, self-powered wearable sensors have become increasingly prevalent in our daily lives. The utilization of piezoelectric composites to harness and sense surrounding mechanical vibrations has been extensively investigated during the last decades. However, the poor interface compatibility between ceramics nanofillers and polymers matrix, as well as low piezoelectric performance, still serves as a critical challenge. In this work, we employed Di(dioctylpyrophosphato) ethylene titanate (DET) as the coupling agent for modifying barium titanate (BTO) nanofillers...

Recently, triboelectric nanogenerators (TENGs) have emerged as having an important role in the next wave of technology due to their large potential applications in energy harvesting and smart sensing. Recognizing this, a device based on TENGs, which can solve some of the problems in the liquid flow measurement process, was considered. In this paper, a new method to measure the liquid flow rate through a pipe which is based on the triboelectric effect is reported. A single-electrode flowing liquid-based TENG (FL-TENG) was developed, comprising a silicon pipe and an electrode coated with a polyvinylidene fluoride (PVDF) membrane...